Walker MDD - Manual (Page 40)

38
ITEM PART DESCRIPTION NO.
NO. NO. REQ’D
ITEM PART DESCRIPTION NO.
NO. NO. REQ’D
Use only genuine Walker ® replacement parts. Effective Date 03-01-06
ELECTRICAL ASSEMBLY
Battery Assembly
1 5975-1 Cable Tie (18# x 3-3/4") 5
2 5933 Battery Terminal Insul., Red (+) 1
3 5844 Battery Hold-Down Bar 1
4 5839 Hook Bolt 2
5 6392 Battery Protector Plate 1
6 7390-1 Battery Pan 1
7 7910 Battery (12V/340CCA/Dry) 1
8 5932 Battery Terminal Insul., Black (-) 1
9 6923 Battery Cable (-) 1
Harness Assembly
10 5975-3 Cable Tie (50# x 7") 4
11 5833 Cable Clamp (1/4) 1
12 5942-4 PTO Safety Switch (NO) 1
13 7940-9 Wire Harness 1
14 5832 Cable Clamp (1/2) 5
15 7944 7.0 Wire Harness 1 *
8950 9.5 Wire Harness 1 *
16 7938 Lead Wire (Battery Charge) 1
17 7306-10 Switch (235 Deg., 1/4-18 NPT) 1
18 7306-11 Switch (205 Deg., 3/8-18 NPT) 1
19 6941 Relay Switch 30/40 Amp (NC) 2
20 7433 Resistor, Ceramic / .4 OHM 1
21 7833 Cable Clamp (7/8 x 1/4) 2
22 7948-2 Time Delay Harness 1
23 7948-1 Time Delay Module 1
24 7428-1 Fan Control Module W/P Plug 1
25 5942-5 Safety Switch (NO) 1
26 5941-5 Safety Switch (NO) 1
27 7203-6 Riser Plate, Seat Switch 1
28 5977-6 Grommet (1 x 1-1/4) 1
29 5975-5 Wire Clip, Self-Mount 3
30 7943 Battery Cable (+) 1
31 8941 Circuit Breaker (30 Amp) 1
(Auto Reset/Sealed)
32 7857-10 Breaker, Mount Bracket 1
33 7941 Circuit Breaker (40 Amp) 1
(Auto Reset/Sealed)
34 7940-5 Circuit Breaker Jumper 1
Fasteners
F002 10-24 Keps Nut 16
F004 1/4-20 Keps Nut 6
F009 5/16-18 Whiz Locknut 1
F019 1/4-20 ESNA Wing Nut 2
F025 10-24 x 3/8 PPHMS 5
F026 10-24 x 1/2 PPHMS 4
F027 10-24 x 5/8 PPHMS 2
F031 1/4-20 x 5/8 Hex Bolt 2
F032 1/4-20 x 3/4 Hex Bolt 2
F050 1/4 SAE Washer 5
F061 1/4 Internal Star Lock Washer 2
F078 A/A64D Aluminum Pop Rivet 2
F079 A/A66D Aluminum Pop Rivet 5
F085 3/16 Rivet Backup Washer 1
F090 1/4-20 x 2-1/2 Hex Bolt 1
F093 5/16-18 x 1 Hex Bolt 1
F116 1/4-20 x 1-1/4 Hex Bolt 1
F129 10-24 x 1/2 PTHMS 1
F182 5/8 x 1/4 x 1/8 Washer 1
F188 1/4-20 Self Locking Nut 1
* Used on GHS Models with 7.0 Bushel Catcher only. When
Optional GHS 9.5 Bushel Catcher is purchased, this part is
replaced by P/N 8950 (9.5 Catcher Wire Harness). Refer to
Optional GHS 9.5 BUSHEL CATCHER ASSEMBLY, Page 34.
NOTE: Refer to ELECTRICAL CONNECTORS, Page 42 for identifi-
cation of all Electrical Wiring Service Parts.
NOTE: Decals for this assembly are not shown here. Refer to
TRACTOR DECALS, Page 2 for Decal listing and placement
information.