Walker MDD - Manual (Page 64)

62
ITEM PART DESCRIPTION NO.
NO. NO. REQ’D
ITEM PART DESCRIPTION NO.
NO. NO. REQ’D
Use only genuine Walker ® replacement parts. Effective Date 03-01-06
TAIL WHEEL LOCK KIT
Kit 8540 Tail Wheel Lock Option / Kit
Includes Items # 1-29, fasteners listed & instructions. May be ordered
as a dealer-installed option. Contact your Walker dealer.
1 5995-2 Switch Boot 1
2 8547 Switch Mount 1
3 8555 Decal, Tail Lock Switch 1
4 5995 Toggle Switch (Off-On) 1
5 7942-4 Single Connector, Male 2 *
6 5940-4 16-14 GA Spg. Loaded Term., Female 5 *
7 5977-1 Grommet (1/8 x 3/8) 1
8 5975-3 Cable Tie (50# x 7") 4
9 8550 Wire Harness 1
10 5975-1 Cable Tie (18# x 3-3/4") 3
11 8553 Splice Tap (18-14 GA) 1
12 8543 Solenoid Mount 1
13 5830-3 Grease Fitting (45 Degree) 1
14 8551 Ground Wire 1
15 8546 Solenoid, Control Module 1
16 5996 1/4 x 16-14 GA QDF Terminal 5 *
(Fully Insulated)
17 8552 Connector Plug & Wire Assy 1
18 8544 Clevis (9/16) 1
19 5551-1 Pivot Bearing 2 *
8545-1 Pivot Bearing Assembly *
(Includes Items # 19, 20, F179 & F350)
20 8544-1 Bearing Spacer (1/4 ID x 9/16) 1 *
21 8542 Tail Wheel Fork, Locking 1
22 8944 3-Way Locking Connector, Male 1 *
23 8944-1 3-Way Locking Connector, Female 1 *
24 5940-5 16-14 GA Spg. Loaded Term., Male 1 *
25 5996-13 16-14 GA Ring Term., #10 1 *
26 7929 Actuating Solenoid 1
27 8549 Sleeve, Delrin 1
28 8541 Plunger Rod 1
8554 Solenoid & Mount Assembly (Includes *
Items # 12-15, 17-20, 26-28, F002, F003,
F004, F029, F050, F179, F190, F198,
F298, F299 & F350)
29 7941-4 Circuit Breaker (25 Amp) **
Fasteners
F002 10-24 Keps Nut 4
F003 1/4-28 Hex Nut 1
F004 1/4-20 Keps Nut 2
F012 3/8-16 Keps Nut 2
F026 10-24 x 1/2 PPHMS 2
F029 1/4-20 x 1/2 Hex Bolt 2
F038 3/8-16 x 1 Hex Bolt 2
F050 1/4 SAE Washer 2
F134 AN960816L Washer 1
F179 1/4-20 x 1 Hex Bolt 2
F190 #10 Internal Star Lock Washer 1
F198 .250 x .625 x .040 Washer, SS 1
F298 3/8-24 Jam Nut 1
F299 10-24 x 1 PPHMS 2
F300 1.015 x 1.500 x .031 Washer 1
F350 1/4-20 LP Nylock 1
* Service Part Only
** Replaces P/N 7941-2 (Circuit Breaker, 10 Amp). Refer to
INSTRUMENT PANEL ASSEMBLY, Page 36.
NOTE: Refer to ELECTRICAL CONNECTORS, Page 42 for identifi-
cation of all Electrical Wiring Service Parts.
NOTE: Upon installation of kit, Item # 4 replaces P/N 5989-4
(Dome Plug, 3/8). Dome Plugs are not shown here. Refer to
BODY / CHASSIS ASSEMBLY (GHS MODELS), Page 4.