Windsor Walk Behind Scrubber SCX326 - Manual (Page 26)

MAINTENANCE
CUTTER 36V 86039100 05/01/07 4-8
4. SCRUB BRUSHES
There are four different types of brushes available to
cover applications from cleaning heavily soiled floors
to polishing. A pad driver is also available to take
advantage of the many cleaning pads on the market.
Please refer to the following to assist in selecting the
proper brush or pad for the work at hand.
UNCOATED FLOORS
Aggressive Grit is a nylon fiber impregnated with
silicone carbide grit. It grinds away stain, soil, and
removes surface material.
Mild Grit is a less aggressive silicone carbide grit
suitable for cleaning medium soil conditions.
Advantages are faster ground speed than nylon
bristles on light solid applications.
Polypropylene is a general-purpose scrub brush
with stiff bristles. Polypropylene works well for
maintaining concrete, wood and tile floors.
FINISHED FLOORS
Nylon bristles are used in a variety of applications
on coated or uncoated surfaces.
White Pads (Polishing) are used for dry polishing to
achieve a high-gloss appearance, or surface
washing on highly polished or burnished floors.
Red Pads (Buffing) are used for light-duty
scrubbing. When used with a mild detergent they
will provide surface cleaning without removing the
finish.
Blue Pads (Scrubbing) are used for heavy-duty
scrubbing and light stripping. The blue pads remove
less finish than brown stripping pads, yet will remove
black marks, stains and dirt.
Black Pads (Stripping) are used for easy and
complete removal of old floor waxes/finishes. They
will quickly remove ground in dirt, black heel marks,
and spills. When used with the proper stripper, this
pad leaves the floor clean and ready for finishing.
The scrub brushes should be checked before each
days work for wire, string, wear and damage.
REPLACING OR INSTALLING SCRUB
BRUSHES
1. With the scrub deck up, turn “OFF” the machine.
FOR SAFETY: Before leaving or servicing the
machine; stop on level surface, turn OFF
machine and remove key.
2. Remove the brush cover shrouds.
3. Locate release lever on top of brush or pad
driver. Rotate release lever counter-clockwise
and the brush/pad driver will release and drop
down.
4. To reinstall, center the brush driver under the
brush drive hub. Raise until it contacts brush
driver assembly. Turn clockwise until release
lever plate locks into position.
5. Replace the brush cover shrouds.
NOTE: Check that release plate is completely
closed and pad/brush is securely attached. Damage
to driver or brush could occur.
5. RECOVERY TANK FLOAT SHUT-OFF
When water is no longer being vacuumed
from the floor and the vacuum fan is
operating, the ball float has engaged. The
vacuum motor will not vacuum water with
recovery tank full. The recovery tank must be
drained.
1. The float shut-off screen can be cleaned in or
out of the machine.
2. To clean the float shut-off while it is inside the
machine wipe material off screen then rinse.
Check that the ball is also clean and moves
freely.
3. To remove the float shut-off, grasp the screen
with one hand and the connected tube with
the other. Tilt and pull the float screen
assembly to pull it off the barb on the tube.
4. To install, place one hand on the tube, and
then tilt and push the float screen assembly
over the barb on the tube.