Dehumidifier safety dehumidifier use (cont.), Warning, Removing & emptying water bucket – Whirlpool AD65USM2 User Manual

Page 7

Advertising
background image

6

1. Use both side handles to lift bucket.

Pull bucket forward and remove.

2. Carry bucket to a large sink or tub.

3. Pour water through opening into a

sink or tub.

4. Replace bucket completely and

check that EMPTY/ADJUST BUCKET
light is off.

WARNING

Sickness Hazard

Do not drink water collected in
water bucket.

Doing so can result in sickness.

Dehumidifier Safety

Dehumidifier Use (cont.)

7

Drain hose connection method:
(to drain water from bucket continuously)

Do not damage
outside, or
connection
will leak.

drain hose connector
cover (not on all models)

center of drain hose connector

3. Attach a garden hose to drain hose

connector. The garden hose should
not be longer than 8 ft (2.4 m). Run
other end of garden hose into a floor
drain. Check that the hose lies flat
and in the drain.

To use the bucket without the garden hose:

Use a garden hose cap to seal the drain
hose connector.

1. If your dehumidifier does not have a

drain hose connector cover, go to
Step 2.

If your dehumidifier has a drain hose
connector cover, use a flat-blade
screwdriver to remove cover from
drain connector. Turn cover
counterclockwise. Discard cover. It
cannot be reused. Go to Step 2.

2. Drill out only the center of the drain

hose connector. Use a minimum

1

4

in. drill bit.

Removing & Emptying Water
Bucket

1187730ENv10 12/3/03 1:12 PM Page 7

Advertising