Wacom DTF-521 - Manual (Page 14)

Installation
Page 12
LCD MONITOR CABLING DIAGRAM
DTF-521, rear view
– B –
DC IN
(12V)
– A –
VGA cable
Video card
Rear panel of your computer
ANALOG RGB OUT
Do not attach the USB data
cable until instructed to do so.
Power adapter – C – To AC outlet
C AUTION Use only the power adapter that came with the DTF-521; use of an improper power adapter
may damage the unit.
Do not connect or disconnect the video or power cables while the DTF-521 or your
computer are turned on – this can damage the display or computer video card.
Make sure that the display refresh rate does not exceed 70 Hz for XGA mode, or 75 Hz
for other modes.
ANALOG RGB IN
VGA port
The ANALOG RGB OUT port is used to
connect a second VGA device such
as a projector or monitor that mirrors
the pen display. Be sure to fully
install the DTF-521 hardware and
software before connecting a
projection device to the unit. Do not
connect or disconnect any cable
while the DTF-521 or your computer
are turned on.
DTF521_Manual.fm Page 12 Thursday, October 25, 2007 3:46 PM