Wacom Cintiq DTZ-2000W - Manual (Page 12)

Unpacking your Cintiq
Page 10
Adjusting the display incline
To adjust the display incline, face the front of the Cintiq pen display and grasp it on the left and right side
at approximately the same height as the Cintiq stand adjustment levers. Use your fingertips to gently
pull the incline adjustment levers toward the display unit; this will release the stand’s clutch mechanism.
Tilt the display to adjust the incline setting.
• To lower Cintiq, pull the left incline adjustment lever toward Cintiq and gently lower Cintiq to the
desired incline angle. Release the lever to lock the stand in place.
• To raise Cintiq, pull the right incline adjustment lever toward Cintiq and gently raise Cintiq to the
desired incline angle. Release the lever to lock the stand in place.
Note: The stand adjustment levers exhibit some natural play before the clutch mechanism
engages. When adjusting the stand incline, set it slightly higher than you plan to work with, then
lower the display to the desired position.
– B –
W ARNING When operating the incline adjustment
levers, Cintiq must be mounted on the
stand with the stand feet resting on a
stable, flat surface. The stand is
spring-loaded and can snap back
quickly, causing injury or damage if
not operated properly.
After the display unit has been mounted on the
stand, remove the foam blocks that lock the
adjustment levers in place. Save these blocks
with the other packaging materials; you will
need them if in the future you want to ship
Cintiq.
W ARNING Before moving Cintiq, first adjust the stand to its full upright position; this will reduce the spring
tension so that the stand will not accidentally release and snap shut. If the display unit is in
landscape orientation, use one hand to grasp the bottom of the display and with your other
hand grasp the back of the stand. Be sure to lift on both the display and the stand so that the
stand will not separate from the display when moving Cintiq. If Cintiq is in portrait orientation or
has been locked to the stand with the rotation lock screws (see page 56), the stand will not
separate from the display unit and Cintiq can be safely lifted by grasping the display unit with
both hands.
Cintiq20WSX_Manual.fm Page 10 Monday, January 15, 2007 9:23 AM