Wacom Cintiq DTZ-2000W - Manual (Page 18)

Installation
Page 16
Step 1: LCD monitor installation
In the first stage of the installation process, Cintiq is installed as a monitor on your system. As you work
through the first stage of the installation process, please refer to the LCD monitor cabling diagram on
page 18 when making cable connections.
Important: Do not connect the USB data cable until instructed to do so.
• Turn off your computer.
Caution: Never connect or disconnect the video or power cables while your computer or Cintiq are
powered on – this can damage the LCD monitor or video card.
• If your computer has only one video connector, you will need to unplug your previous monitor.
Determine if your computer has a digital (DVI-I or DVI-D) or analog (VGA) connector, and set the
D
IGITAL /A NALOG (DVI/VGA) switch located on the back of Cintiq for the video connection you are
using. Move the switch toward the tablet edge for Digital (DVI-I or DVI-D), and move it toward the
OSD buttons for A
NALOG (VGA). See – A – in the connection diagram on page 18.
• Follow the instructions below for your video connector. See – B – in the diagram on page 18.
If you are connecting to a DVI-I connector, plug the Cintiq video cable
into the DVI-I connector of your video card.
If you are connecting to a DVI-D connector, plug the Cintiq video cable
into the DVI-D to DVI-I adapter supplied with Cintiq, and then plug the
adapter into the DVI-D connector on your video card.
If you are connecting to a VGA connector, plug the Cintiq video cable
into the VGA to DVI-I adapter supplied with Cintiq, and then plug the
adapter into the VGA connector on your video card.
DVI-I connector
DVI-D connector
VGA connector
Cintiq20WSX_Manual.fm Page 16 Monday, January 15, 2007 9:23 AM