Wolfcraft 4525 - Manual (Page 3)

3
Introduction
Precision hole drilling and countersinking is a
skill that ordinarily takes years to acquire. Yet
the success of many projects depends on
drilling straight, accurate holes.
Your wolfcraft Drill Guide, when used with
your power drill, makes it easy to perform
many precision operations, including straight
and angled drilling, edge and round stock
drilling, countersinking and edge sanding. It
provides you with better control for a better
finished result.
You can use your wolfcraft Drill Guide any-
where you need a drill—even in masonry or
concrete using the proper bit.
Unpacking and
Checking Contents
Separate all parts from the packing materials
and check them against the illustration and
the “Table of Parts.” Make sure all parts are
accounted for before discarding any of the
packing material.
FIG 1
A
L
K
A
L
K
D
C
E
F
I
I
J
J
E
M
G
H
B
Assembling Your Drill
Guide
(See Figure 1)
You must read and understand
all the instructions of your Drill
Guide as well as your drill owner’s manual
before attempting to assemble and operate this
product.
1. Secure handle (G) to base plate (F) with nut
(H). The ribs in base plate will hold nut in
position while tightening handle.
2. Remove springs (K) from both guide bars
(A). Slide guide bars into cross guide/chuck
assembly (B). Position springs back on
guide bars.
3. Thread thumb screw (C) into cross
guide/chuck assembly.
4. Slide depth stop (D) onto guide bar under
thumb screw in cross bar/chuck assembly.
Position thumb screw on depth stop facing out.
5. Place bar holders (E) on guide bars. Rotate
bar holders so index marks are facing out.
6. Install hex screw (J) through each support
(I). Position guide bars on base plate with
tabs on bar holders passing through slots in
base plate. Hold guide bars vertical and
install supports. Rotate caps (L) clockwise
on top of guide bars to tighten screws.
Figure 1
TABLE OF PARTS
ITEM DESCRIPTION QTY.
A Guide Bar/Spring Assembly 2
B Cross Guide/Chuck Assembly 1
C Thumb Screw 1
D Depth Stop 1
E Bar Holder 2
F Base Plate 1
G Handle 1
H Nut 1
I Supports 2
J Hex Screw 2
K Springs 2
L Caps 2
M Chuck Key 1
WARNING