White Outdoor RB-530 - Manual (Page 11)

11
Belt Replacement
• Disconnect and ground the spark plug wire against
the engine.
• Remove two torx head screws from the top of belt
cover.
• Remove two hex cap nuts and flat washers from
front side of the belt cover. Remove the hex nut and
flat washer at the back of the cover.
• Remove the belt keeper assembly located behind
the engine pulley by removing two hex bolts and
lock washers. See Figure 12.
Figure 12
• Remove belt and reassemble new belt, following
instructions in reverse order.
NOTE: Upon reassembly, make certain the belt is
routed over the idler pulley and inside of belt keepers by
engine pulley.
Off-season Storage
• Clean the exterior of engine and the entire tiller
thoroughly. Lubricate the tiller as described in the
Lubrication Section.
• Refer to the engine manual for correct engine
storage instructions.
• Wipe tines with oiled rag to prevent rust.
• Store tiller in a clean, dry area. Do not store next to
corrosive materials, such as fertilizer.
Engine
Pulley
Belt Keeper
Hex Bolts
Belt
Keeper
Idler
Pulley