White Outdoor RB-530 - Manual (Page 6)

6
Figure 3
• Place the hex opening of the hex nut retainer
bracket over the flange nut securing the handle
adjustment lock and install the lock nut on the lower
shoulder bolt. See Figure 4.
• Pivot handle assembly into the highest position
possible. Tighten the bottom bolt and nut securely.
Tighten the handle adjustment lock.
Figure 4
Attaching The Gear Shift Rod
• Remove the T-handle, nut, hairpin clip, flat washer
and rubber washer from the end of the gear shift
rod. Slide the rod up through the bracket on the
front of the handle assembly. See Figure 5.
Figure 5
• Insert the end of the gear shift rod through the
opening in the top of the shift cover, and into the
shift bracket. Secure with rubber washer first, then
flat washer and hairpin clip. See Figure 6.
• Install the nut and T-handle on the gear shift rod.
Figure 6
Attaching The Clutch Cable
• Route the clutch cable underneath the handle and
through the cable clip. Be careful not to bend or
kink the cable. See Figure 7.
Figure 7
• Remove one hex nut from the threaded casing on
the end of the cable and slip the wire up through the
slot on the cable bracket underneath the handle.
See Figure 8.
• Push the end of the casing up through the cable
bracket. Rethread the hex nut on the end of the
cable. Do not tighten at this time.
• Pull the cable upwards to obtain slack and from
right to left hook the “Z” end of the cable into the
bracket on the clutch control (beneath the handle
panel). Tighten the nut against the cable bracket.
See Figure 8.
Lift up
Handle
Flange Nut Retainer Bracket
Shoulder Bolt
Lock Nut
Hex Hole in
Retainer Bracket
over Flange Nut
Handle Adjustment
Lock
T-Handle
Gear Shift
Rod
Shift Cover
Gear Shift Rod
Opening
Rubber Washer
Flat Washer
Hairpin Clip
Handle
Adjustment
Lock
Cable
Clip
Flange Lock Nut