Wisdom Audio Wisdom & Sage Series SC-1 User Manual
Page 35
35
Options/Microphone Selection
Important: choose the serial number of the microphone you are using. All mea-
surements are filtered through a calibration file that ensures their accuracy.
Multi-Zone Setup (part 2)
In System Configuration, you established the total number of main and sub-
woofer channels being used. (See pages 26-27.) In our example, Zone 1 had 5.1
channels, and Zone 2 had 2.1 channels, for a total of 7.2 channels used (out of
the 7.3 that the SC-1 supports). MultEQ Pro initially assumes that all speakers are
in Zone 1, as shown below.
Zone Configuration
The Zone Configuration screen allows you to reassign specific channels to either
a second or a third zone, using the radio buttons and pulldown menus. In this
case, for example, you might put channels 5, 6, and 9 into Zone 2. This would
give you a 5.1 system for your main theater that uses the Left, Center, Right, and
Surround outputs along with Subwoofer 1, while the second zone utilized the
“Back” channels and Subwoofer 2.
This Zone Configuration process is critical, since it defines when the speakers
are “chirped” for measurements by breaking them into groups. You can thus
“chirp” all of Zone 1 and then move the microphone to the second zone before
resuming with the measurements.