Wisdom Audio Wisdom & Sage Series SC-1 - Manual (Page 7)

7
Placement Considerations
PRECAUTION
For your protection, review “Important Safety Instructions” and
“Operating Voltage” before you install your SC-1.
Note that adequate clearance for the AC cord and connecting signal cables
must be left behind your SC-1. We suggest leaving at least six inches (15 cm) of
free space behind your SC-1 so all cables have sufficient room to bend without
crimping or undue strain.
If possible, the SC-1 should also be placed in such a way that the power switch
on the rear panel is easily accessible. This switch disconnects power from the
unit completely, resulting in effective disconnection of the SC-1 from the AC
mains. You might think of this as a “vacation switch,” should you wish to turn
off your system completely when you will be away from home for a prolonged
period of time. Just remember to turn it back on again when you return.
Ventilation Your Wisdom Audio SC-1 contains many active devices and a great deal of
signal processing. It will run quite warm under normal operation. It should not
be placed directly on top of another component that generates significant heat,
such as most power amplifiers. Do not block the vents on the sides of the unit.
Mechanical drawings are included in this manual to facilitate special installa-
tions where necessary (see “Dimensions” at the end of this manual).