Wolf Appliance Company DUAL FUEL RANGES - Manual (Page 16)

CLEANING
INSTRUCTIONS
NOTE: To keep the charbroiler
looking its best, it is recom-
mended to clean after every use.
Do not use any commercial
cleaners on any part of the
charbroiler assembly.
1) Remove the charbroiler
grate.
2) Remove the front angled
deflector plate.
3) Remove the charbroiler
decorative frame.
4) After cleaning, put charbroiler
decorative frame back in place.
5) Line up the two small tabs
on the bottom of the front
angled deflector plate with the
notches in the decorative frame.
The two tabs should fit securely
in the notches, and the front
angled deflector plate should
rest along the front of the
decorative frame.
6) Reinstall charbroiler grate.
• Igniter (ceramic): Avoid
contact with the igniter; it is
fragile and can chip or break.
16
W
O L F
C
H A R B R O I L E R
F
E A T U R E
C H A R B R O I L E R C A R E
A N D C L E A N I N G
• Charbroiler Grate (porcelain-
coated cast iron): When cool,
lift off and set in the sink. Pour
very hot water over the cooked
on residue. Cover with wet
dishtowels and pour more hot
water over it. Allow the hot,
moist conditions to help loosen
the residue. Remove remaining
soil with a soap-filled scouring
pad. Rinse and dry.
• Charbroiler Frame and
Front Angled Deflector Plate
(stainless steel): Remove from
the range. Soak in hot water
and dish detergent. Wash thor-
oughly, scrubbing with scouring
pad, if needed.
CAUTION
Be careful when assem-
bling the components.
Avoid any contact with the
igniter; it is fragile and
can chip or break.
CHARBROILER
GRATE
Charbroiler grate
IGNITER
CHARBROILER
FRAME
FRONT
ANGLED
DEFLECTOR
PLATE
TAB
Charbroiler interior components
CAUTION
Allow the charbroiler
surface to cool sufficiently
before cleaning surfaces.