Whirlpool ACE184PT0 - Manual (Page 13)

13
Timer Delay
To set the Timer to turn off the air conditioner (the air
conditioner must be On):
1. Press TIMER. Timer indicator light will flash. Display will show
remaining hours before the air conditioner will turn off.
2. Press the plus or minus button to change the delay time from
1 to 24 hours.
3. Press TIMER again or wait 10 seconds. Timer indicator light
will remain on. Display will show the current room
temperature.
To set the Timer to turn on the air conditioner, keeping
previous settings:
1. Turn off the air conditioner.
2. Press TIMER. Timer indicator light will flash. Display will show
remaining hours before the air conditioner will turn on.
3. Press the plus or minus button to change the delay time from
1 to 24 hours.
4. Press TIMER again or wait 10 seconds. Timer indicator light
will remain on. Display will show current room temperature.
To set the Timer to turn on the air conditioner, changing
previous settings:
1. Turn on the air conditioner.
2. Adjust the mode to Cool, Fan Only, or Power Saver.
3. Adjust the fan speed to Turbo, High, Low or Auto.
4. Adjust temperature between 64°F and 86°F (18ºC and 30ºC).
5. Turn off the air conditioner.
6. Press TIMER. Timer indicator light will flash. Display will show
remaining hours before the air conditioner will turn on.
7. Press the plus or minus button to change delay time (1 to
24 hours).
8. Press TIMER again or wait 10 seconds. Timer indicator light
will remain on. Display will show current room temperature.
To clear Timer delay program:
NOTE: Air conditioner can be either on or off.
Press and hold TIMER for 3 seconds. Timer indicator light will
turn off.
To see or change the time remaining (in hours):
1. Press TIMER once after it has been programmed. Display will
show remaining time.
2. While the display is showing the remaining time, you can
press the plus or minus button to increase or decrease the
time.
3. After 10 seconds, display will show the current room
temperature.
Using the Remote Control
NOTE: Remote control may vary in appearance.
NOTE: Two AAA batteries (included) power the remote control.
Replace batteries after 6 months of use, or when the remote
control starts to lose power.
To Turn the Air Conditioner On or Off
Press POWER.
To Select the Mode
Press COOL, FAN, or POWER SAVER.
To Select the Fan Speed
Press FAN SPEED for Turbo, High or Low or Auto.
NOTE: Auto fan speed cannot be selected in Fan Only mode.
To Set the Temperature
To raise the temperature:
Press the plus button to raise the temperature. Each time you
press or hold the plus button, the temperature will go up 1º to a
maximum temperature of 86°F (30°C).
To lower the temperature:
Press the minus button to lower the temperature. Each time you
press or hold the minus button, the temperature will go down 1º
to a minimum temperature of 64°F (18°C).
SPEED
COOL FAN FAN
SWING
TIMER
POWER
Power saver
POWER
FAN COOL
Power saver
SPEED
FAN AUTO