Whirlpool ACE184PT0 User Manual
Page 7
7
Attach Side Curtains
1. Locate the bag of screws provided.
2. Insert the top and then the bottom of the right-hand curtain
housing in the top and bottom curtain guides on the air
conditioner.
Top view
Bottom view
3. Extend the right-hand curtain outward so you may insert the
first screw through the middle hole of the curtain. Using
#10 x
¹⁄₄" pan-head Phillips screw, screw the curtain to the
middle hole in the air conditioner cabinet.
NOTE: This screw is required to correctly attach the curtain
(top to bottom) to the air conditioner cabinet.
4. While the right-hand curtain is still extended, insert #10 x
¹⁄₄"
pan-head Phillips screws into the top and bottom slots of
curtain. Screw the curtain to the top and bottom holes in the
air conditioner cabinet.
NOTE: Some curtains may have 2 slots at each end. You will
be able to see a mounting hole through the correct slot.
5. Slide the curtain housing into the curtain guides as far as it
will go.
6. Repeat the above steps for the left-hand curtain.
Attach foam adhesive seal
Attach the foam adhesive seal along the bottom of the bottom
curtain guide.
Install Cabinet into Window
NOTES:
■
Handle the air conditioner gently.
■
Be sure your air conditioner cabinet does not fall out of the
opening during installation or removal.
■
The location where the power cord exits the air conditioner
should be no more than 4 ft (122 cm) from a grounded
3 prong outlet.
■
Do not block the louvers on the front panel.
■
Do not block the louvers on the outside of the air conditioner.
1. Center the empty cabinet in the window. Check that the lower
rail of the air conditioner cabinet is behind and against the
back side of the windowsill. Maintain a firm hold on the air
conditioner cabinet. Lower the window sash to hold the
cabinet in place.
2. Measure the distance between the right-hand side of the
cabinet and the inside of the window channel.
A. Curtain housing
B. Curtain guides
A. Curtain housing
B. Curtain guides
A
B
A
B
A. Curtain housing
B. Foam adhesive seal
A
B