Whirlpool 8053373A - Manual (Page 24)

24
Range
Front frame
hinge slot
2. Hold oven door so that the top edge of each
hinge hanger is horizontal. Insert hinge hangers
into the front frame hinge slots.
3. Tilt top of door toward range. Slide hinge
hangers down onto front frame support pins.
NOTE: Make sure the hinge hangers are fully seated
and engaged on the support pins.
4. Insert the door stop clip with the angular surface
at the top of the frame hinge slot, then push in
the bottom of the clip until flanges are flush with
the front frame.
5. Open the door completely and remove the door
removal pins. Save door removal pins for future
use.
6. Close the door.
Door removal
pin hole
Hinge
hanger
Door stop
clip
Angular
surface of
door stop
clip
Door removal
pin hole
Support pins
R
EMOVING THE OVEN DOOR
( CONT
.
)
You can remove the panel in the oven bottom
for cleaning.
To remove:
1. Let oven cool.
2. Remove the oven racks.
3. Remove the 2 hold-down screws at the rear of
the oven. If the screws are too tight to remove
by hand, use a screwdriver.
R
EMOVING THE OVEN BOTTOM
Remove
CARING FOR YOUR RANGE