Weider 831.159720 - Manual (Page 6)

6
1. Before beginning, make sure that you have read
and understood the information on page 5.
Locate and open the parts bag labeled “FRAME
ASSEMBLY.”
Press a 2” Square Inner Cap (38) into the Butterfly
Base (61). Press two 2” Square Inner Caps (38) into
the Press Base (60).
Insert four 5/16” x 2 1/2” Carriage Bolts (1) up
through the indicated holes in the Butterfly Base (61)
and the Press Base (60). Note: If the Bolts fall out,
secure them by putting a small piece of tape over
the head of each Bolt. Place the Butterfly Base and
Press Base flat on the floor.
Attach the Press Base (60) to the Butterfly Base (61)
with two 5/16” x 2 3/4” Bolts (20), two 5/16” Flat
Washers (19), and two 5/16” Nylon Locknuts (2).
2. Position the Butterfly Upright (62) as shown. Place
the bracket on the lower end of the Butterfly Upright
(62) over the indicated 5/16” x 2 1/2” Carriage Bolts
(1) in the Butterfly Base (61). Hand tighten two 5/16”
Nylon Locknuts (2) onto the Bolts. Do not tighten the
Nylon Locknuts yet.
Place the bracket on the lower end of the Press
Frame Upright (59) over the indicated 5/16” x 2 1/2”
Carriage Bolts (1) in the Press Base (60). Hand tight-
en two 5/16” Nylon Locknuts (2) onto the Bolts. Do
not tighten the Nylon Locknuts yet.
Frame Assembly
1
1
61
38
2
1
1
19
20
38
60
1
38
2
2
2
1
1
2
59 62
Position
with the
Bracket
on this
side
60 61