Weider Pro 4850 831.153932 - Manual (Page 17)

17
45. Wrap the Swivel Low Cable (72) under a 90mm
Pulley (78). Attach the Pulley to the indicated brack-
et on the Long Base (106) with an M10 x 45mm
Bolt (93) and an M10 Nylon Locknut (87).
46. Route the Swivel Low Cable (72) under the indicat-
ed stack of Weights (44).
Wrap the Swivel Low Cable (72) under a 90mm
Pulley (78). Attach the Pulley to the indicated brack-
et on the Long Base (106) with an M10 x 45mm
Bolt (93) and an M10 Nylon Locknut (87).
47. Wrap the Swivel Low Cable (72) over a 90mm
Pulley (78). Attach the Pulley and a Cable Trap (68)
between the indicated holes in the Pulley Plates
(63) with an M10 x 50mm Bolt (100) and an M10
Nylon Locknut (87).
Make sure that the Cable
Trap is turned to hold the Cable in the groove of
the Pulley.
48. Wrap the Swivel Low Cable (72) under a 90mm
Pulley (78). Attach the Pulley to the indicated brack-
et on the Short Base (2) with an M10 x 45mm Bolt
(93) and an M10 Nylon Locknut (87).
48
44
46
45
47
61
78
72
93
106
78
44
72
72
87
93
87
106
68
100
63
2
72
93 87
78
78
87
44. Wrap the Swivel Low Cable (72) over a 90mm
Pulley (78). Attach the Pulley to the Offset Double
“U”-bracket (61) with an M10 x 45mm Bolt (93) and
an M10 Nylon Locknut (87).
72
87
78
93