Weider Pro 4850 831.153932 - Manual (Page 7)

4. Press a 38mm Square Inner Cap (67) into the
square tube on the Butterfly Upright (3).
Slide the Butterfly Upright (3) onto the two indicated
M10 x 65mm Carriage Bolts (110) in the Short Base
(2). Finger tighten an M10 Nylon Locknut (87) onto
each Carriage Bolt.
Do not tighten the Locknuts
yet.
5. Press a 50mm x 75mm Inner Cap (58) halfway into
the top of the Seat Upright (9); it will need to be
removed later. Attach the Leg Lever Bumper (77) to
the Seat Upright with an M4 x 20mm Self-tapping
Screw (14) and an M4 Washer (98).
Slide the Seat Upright (9) onto the two indicated
M10 x 65mm Carriage Bolts (110) in the Short Base
(2). Finger tighten an M10 Nylon Locknut (87) onto
each Carriage Bolt.
Do not tighten the Locknuts
yet.
7
4
3
87
110
87
2
67
5
2
110
87
87
77
14
58
9
98
6
9
92
92
91
3
91
91
91
87
87
8
6. Hold the Seat Frame (8) between the Seat Upright
(9) and the Butterfly Upright (3). Attach the Seat
Frame to the Seat Upright with two M10 x 95mm
Bolts (92), two M10 Washers (91), and two M10
Nylon Locknuts (87).
Do not tighten the Locknuts
yet.
Attach the Seat Frame (8) to the Butterfly Upright
(3) with two M10 x 95mm Bolts (92), two M10
Washers (91), and two M10 Nylon Locknuts (87).
Do not tighten the Locknuts yet.