Western Telematic 12651 - Manual (Page 5)

2.2. Back Panel
As shown in Figure 2, the RPB+ back panel includes the
following items:
À
Switched AC Outlets (Plugs 1 - 5): For connection to up
to five AC devices. Each outlet is capable of switching up
to 15 Amps. The total for all five outlets must not exceed
15 Amps.
Á
SetUp Switches (RATE): A bank of four DIP Switches
which set the Control Port baud rate, select the Off Time
duration, enable/disable the Password Option, and
enable/disable the Read Only Mode.
Â
RS232 (Control) Port: For connection to an external
modem or local PC. The RPB+ accepts ASCII commands
via the Control Port.
à DEFAULT Button: Reads Rate Switch settings and sets
parameters accordingly. This allows the user to change
Rate Switch settings without re-booting the RPB+ and
connected devices. The Default Button can also be used to
bypass the Password Prompt.
Ä
Power Cable (115 VAC Units)
Power Cable Receptacle (230 VAC Units)
Å Circuit Breaker: 15 Amps
Æ
Power Switch
Page 3
Unit Description
Figure 2: Back Panel