Operating instructions – weber S-470TM User Manual

Page 11

Advertising
background image

11

WWW.WEBER.COM

®

11

SNAP IGNITION OPERATION

ƽ Always open the lid before igniting the burners

Each control knob has its own igniter electrode built in. To create a spark you must push
the control knob in (A) and turn to “START/High” (B).

This action will generate gas flow and a spark to the burner lighting tube (C). You will
hear a “snap” from the igniter. You will also see a 3˝ - 5˝ orange flame coming from the
burner lighting tube at the left side of the burner (D).

Continue to hold the burner control knob in for two seconds after the “snap”. This
will allow gas to flow completely down the burner tube (E) and insure ignition.

LIGHTING

Summary lighting instructions are inside the left hand cabinet door.

ƽ DANGER

Failure to open the lid while igniting the barbecue’s burners,
or not waiting 5 minutes to allow the gas to clear if the
barbecue does not light, may result in an explosive flame-up
which can cause serious bodily injury or death.

MAIN BURNER SNAP IGNITION

Note: Each control knob snap igniter creates a spark from the igniter electrode to the
burner lighting tube. You generate the energy for the spark by pushing in the control
knob and turning to “START/HI”. This will ignite each individual burner.

ƽ WARNING: Check hose before each use of barbecue for

nicks, cracking, abrasions or cuts. If the hose is found to
be damaged in any way, do not use the barbecue. Replace
using only Weber

®

authorized replacement hose. Contact

the Customer Service Representative in your area using the
contact information on our web site.
Log onto www.weber.com

®

.

3

1

5

2 4

* The grill illustrated may have

slight differences than the
model purchased.

OPERATING INSTRUCTIONS

Check that the burner is lit by looking through the cooking grates. You should see a
flame. If burner does not light on first try, push control knob in and turn to OFF.Repeat
lighting procedure a second time.

ƽ WARNING: If the burner still does not light, turn the burner

control knob to “OFF” and wait 5 minutes to let the gas clear
before you try again or try to light with a match.

Advertising