Zanussi ZCM 650 ZCM 651 - Manual (Page 24)

24
If you turn the oven knob to a cooking function while
the pyrolytic function is active, the cleaning cy-
cle will be interrupted.
If the oven door lock is activated, it is impossible to
select any cooking until the door lock is off.
To programme the pyrolytic
cleaning cycle (delayed start,
automatic stop)
If you wish, you can programme the starting and end-
ing time of the pyrolytic cleaning cycle.
1. Turn the oven knob to position . The “Cook
Time” indicator and the PYr I indication will flash in
the display (Fig. 22).
2. Press “Pyrolytic” button to activate the pyrolytic
cleaning function. The temperature indicators will
start lightning alternatively. This means that the
oven is rapidly heating up.
The“PYr I” indication will stop to flash, the oven light
goes out and the pyrolytic cleaning cycle starts
(Fig. 24).
If the oven cavity is a lot dirty, we advise you to select the
pyrolytic 2 function (PYr 2) on the programmer display.
1. Press “Pyrolytic” button to select the pyrolytic 2
(PYr 2) function.
2. Press button “Time” twice to display the end time of
the cleaning cycle. After the setting is carried out,
the “Cook Time” and “End Time” indicators will light
permanently.
3. Turn the time/temperature control knob to to
select the the end time of the cleaning cycle.
The pyrolytic cleaning cycle will start according to the
programmed time. The temperature level indicators will
light up alternatively. This means that the oven is rapidly
heating up.
After some time, the temperature level indicators will
light permanently in the display. This means that
the oven door has been locked.
At the end of the pyrolitic cleaning process, “0.00” will
flash in the display.
Once the oven has cooled down (check the tempera-
ture level indicators coming off one by one), the
oven door will unlock.
To reset the oven, turn the oven function control knob to
the “OFF” position (0).
If you press a button other than the knob, the alarm will
switch off and the display will show “--- °C”. This means
that the oven cannot be operated.
To reset the oven, turn the oven function control knob to
the “OFF” position (0).
To stop the pyrolytic cleaning cycle at any time, turn
the oven function control knob to the “OFF” position
(0).