Zanussi ZWH6140 P - Manual (Page 15)

3
Automatic Spin reduction and
Rinse Hold
Spin
By selecting a programme, the appliance proposes automatically the maxi-
mum spin speed provided for that programme.
By selecting Automatic Spin reduction ( ) the spin speed is reduced to a
half, but not less than 400 rpm. The relevant light illuminates.
Rinse Hold
By selecting this function the water of the last rinse is not emptied out to
prevent the fabrics from creasing. Before opening the door it will be neces-
sary to empty out the water.
To empty out the water, please read the paragraph «At the end of the pro-
gramme».
4
Super Quick By pressing this button the corresponding pilot light illuminates.
Short cycle for lightly soiled items or for laundry which needs only freshen-
ing up.
With this option, a reduced load of laundry is recommended:
• Cottons 3,5 kg
• Synthetics and delicates 2 kg
3
+
4
Extra Rinse
Spin
Super
Quick
This appliance is designed for saving water. However, for people with very
delicate skin (allergic to detergents) it may be necessary to rinse the laundry
using an extra quantity of water.
Press simultaneously the buttons 3 and 4 for some seconds: the pilot light
7.2 comes on. This function stays permanently on. To remove it press the
same buttons again until the pilot light 7.2 goes off.
5
Delay Start
3h 6h 9h
Delay Start
The start of the programme can be delayed by 9, 6 or 3 hours by means of
this button. The relevant light illuminates.
You must select this option after you have set the programme and before
you start the programme.
Select a delayed start:
• select the programme and the required options;
• select the delay start by pressing the button 5;
• press the button 6:
– the appliance starts its hourly countdown.
– The programme will start after the selected delay has expired.
Cancelling the delayed start after having started the programme:
• set the appliance to PAUSE by pressing the button 6;
• press the button 5 once, the light relevant to the selected delay goes off;
• press the button 6 again to start the programme.
The DELAY START cannot be selected with the drain programme.
15