Zanussi ZWH6140 P - Manual (Page 22)

The filter is inserted correctly when the indicator on its
top is visible and blocked.
• close the filter cover;
• insert the mains plug
again.
Cleaning the water inlet filters
Important! If the appliance doesn't fill, it takes a long time
to fill with water, the starting button flashes red or the
display (if available) shows the relevant alarm (see chapter
"What to do if..." for more details), check if the water inlet
filters are blocked .
To clean the water inlet filters:
• Turn off the water tap.
• Unscrew the hose from
the tap.
• Clean the filter in the
hose with a stiff brush.
• Screw the hose back onto the tap. Make sure the
connection is tight.
• Unscrew the hose from
the appliance. Keep a
towel nearby because
some water may flow.
• Clean the filter in the
valve with a stiff brush
or with the piece of
cloth.
• Screw the hose back to the appliance and make sure
the connection is tight.
• Turn on the water tap.
What to do if…
The appliance does not start or stops during operation.
Certain problems are due to lack of simple maintenance or
oversights, which can be solved with the help of the indi-
cations described in the charts, without calling out an en-
gineer.
During appliance operation it is possible that the red pilot
light of the button 6 flashes and one of the indicator pilot
lights illuminates to indicate that the appliance is not
working.
Before contacting your local Service Centre, please carry
out the checks listed below.
Fault code and malfunction Possible cause - Solution
The light of button 6 flashes and the light 7.1 illuminates: Problem with the water supply
22