Zanussi ZWH6140 P - Manual (Page 16)

Important! The selected delay can be changed only after selecting the wash-
ing programme again. The door will be locked throughout the delay time. If
you need to open the door, you must set the appliance to PAUSE (by press-
ing the button 6) and then wait a few minutes. After you have closed the
door, press the button 6 again.
6
Start/Pause
Start /Pause
Start the programme by pressing the button 6
• To start the selected programme, press the button 6, the corresponding
green pilot light stops flashing. The pilot light 7.1 illuminates to indicate
that the appliance starts operating and the door is locked. If you have
chosen a delayed start, the appliance will begin the countdown.
• To interrupt a programme which is running, press the button 6: the cor-
responding green pilot light starts flashing. It is possible to change some
options of a running programme before the programme carries them out.
• To restart the programme from the point at which it was interrupted,
press the button 6.
• After the programme has started the door is locked. If, for any reason,
you need to open the door, set firstly the appliance to PAUSE by pressing
the button 6. After a few minutes it will be possible to open the door.
If the door remains locked, this means that the appliance is already heat-
ing or that the water level is too high. In any case, do not try to force the
door!
If you cannot open the door but you need to open it you have to switch
the appliance off by turning the selector dial to . After a few minutes
the door can be opened (pay attention to the water level and tempera-
ture!). After closing the door, it is necessary to select the programme and
options again and to press the button 6.
,
.
7.1
7.2
7.3
Indicator pilot lights • When you start the programme by pressing the button 6, the washing
phase pilot light (7.1) illuminates. This means that the appliance is oper-
ating.
• The additional rinses pilot light (7.2) illuminates when the appliance per-
forms an extra rinse.
• When the programme has finished the end cycle pilot light (7.3) comes
on.
At the end of the programme
The appliance stops automatically. The pilot light of the
button 6 and the pilot light corresponding to the just fin-
ished washing phase go off. The light 7.3 illuminates.
If a programme or an option that ends with water left in the
tub has been selected and the door remains locked to in-
dicate that the water must be emptied out before opening
the door.
Follow the below instructions to empty out the water:
• Turn the programme selector dial to .
• Select the draining or spinning programme.
• Reduce the spin speed if needed, by pressing the rele-
vant button.
• Press the button 6.
At the end of the programme, the door can be now
opened. Turn the programme selector dial to to switch
the appliance off.
Remove the laundry from the drum and carefully check
that the drum is empty. If you do not intend to carry out
16