XM Satellite Radio XMD076A - Manual (Page 17)

Installation Manual
XMD076A
XMD076A-3 Information is subject to the 13
Rev C , 06/22/06 restrictions on the title page
H E A D S U P T E C H N O L O G I E S
3.0 System Checkout
The following XMD076A system-checkout aides are intended to assure proper
installation and interfacing to the MFD, antenna and audio system. Familiarize yourself
with:
•
The MFD operational guide for explanations of using the MFD to communicate with
the XMD076A.
•
The XMC050 Controller operations guide.
•
The audio system configuration to verify the XMD076A audio performs as intended.
3.1 Initial Installation Validation Test
Before applying power to the system, verify and complete the following:
•
100% continuity check performed and satisfactory.
•
All interconnects and ground connections are fully made and seated.
•
The aircraft’s power source is at the proper voltage, 11VDC - 16VDC for 14V
aircraft and 22VDC - 32VDC for 28V aircraft.
•
Move aircraft to an outdoor area with a clear view of the southern sky, free of
buildings, trees or other obstructions.
•
Verify the XMC050 remote controller is set to the “receiver ID” of the XMD076A.
The “receiver ID” is located on the nameplate of the XMD076A.
3.2 System Test
3.2.1 Service Activation
The system requires two service activations from XM Satellite Radio Inc. - one for the
XM WX Satellite Weather service and another for the XM Radio. For installation
purposes only, temporary XM WX and the XM Radio services are pre-activated from the
factory. This activation will terminate automatically without prior notice. To avoid
unexpected deactivation, customers should contact XM Satellite Radio Inc. at 1-
800-985-9200 to transfer the subscriptions immediately after installation.
NOTE: The weather activation process for the XMD076A is the same as the XMD076.
Please contact Heads Up Technologies via email at [email protected] for
additional information on the process to activate receivers if required.