Xantrex Technology Xantrex AC to DC Converter XADC - Manual (Page 21)

Installation Instructions
975-0301-01-01 21
Connecting the Panel to the XADC AC Side
When following the procedure, see Table 2 on page 24 for wire lengths and
Table 1 on page 24 for torque values. See Figure 4 on page 8 for panel electrical
connection diagrams. Refer to local electrical codes for wire gauge sizes.
To connect the panel to the XADC AC side:
1. Remove the AC wiring compartment panel on the XADC (see Figure 8).
2. Route the all AC cables from the XADC, through the AC wiring compartment
hole in the top of the XADC. Ensure factory-installed grommet is still present.
3. Connect the AC ground (green) cable from the XADC to the front AC bus on
the panel, marked “Equipment Grounding Terminal”.
4. Connect the neutral (white) cable from the XADC to the rear AC bus on the
panel, marked “AC Neutral Terminal”.
5. Connect the AC line black cable from the XADC to the any breaker on the
panel that is not reserved for the AC main line. Tighten as per the
manufacturer’s recommended torque rating (usually located on the side of
breakers).
Figure 16 Connecting Panel to XADC AC Side
XADC AC cables to
any breaker except
reserved AC line
breaker
AC wiring
compartment hole
XADC AC neutral
connection to AC
Neutral Terminal
XADC AC ground
connection to
Equipment
Grounding Terminal
AC line connection
to breaker 1 (30A
panel) or breaker
4+5 (50A panel)