Yamaha YHT-470 - Manual (Page 14)

1
Follow steps 1 – 3 on page 12.
2
* The unit will automatically program tracks for side A and
side B separately considering the tape’s total time.
3
Begin recording on the tape deck and press the PLAY
button on this unit at the same time.
4
The unit will pause at the end of side A of the tape.
Turn the tape over to side B. Resume recording and, at
the same time, press the PLAY button or the PAUSE
button on this unit.
Notes
• Because the programmed data changes every time the
RANDOM button is pressed, the amount of time remaining
at the end of the tape also changes accordingly.
• If the tape’s length is not enough, all tracks cannot be
programmed. In this case, exchange the tape for a longer
one.
• In step 2, you can check the program data for side A and
side B.
➀ Shows the number of programmed tracks.
➁
Shows the total time of programmed tracks.
➂
Shows the side of the tape.
➃ Shows the programmed track numbers.
Ⅲ
Random sequential tape-programming
The unit will automatically program tracks in random sequential order for recording to tape.
14
LOGODISK
RANDOM
4
2 1
3
4
2
3, 4