Yamaha DSP-AX1 - Manual (Page 24)

22
Preparations
Hookups
■ Connecting a Rear Subwoofer
By using both Front and Rear Subwoofers, the CINEMA-DSP sound field
programs can produce realistic movie effects with powerful, dynamic sound. To
take advantage of this dynamic sound, be sure to set the 1C. REAR L/R SP item
in the SET MENU to “LARGE” (see page 37), and connect your Rear speakers
and Subwoofer as shown below.
1 1 Connect the right + input terminal on your Subwoofer to the REAR
R + terminal, and the right – input terminal on your Subwoofer to
the REAR R – terminal with speaker cords.
2 2 Connect the left + input terminal on your Subwoofer to the REAR
L + terminal, and the left – input terminal on your Subwoofer to the
REAR L – terminal with speaker cords.
3 3 Connect your Rear speakers to the output terminals on the Rear
Subwoofer.
Be sure to connect the Rear speakers to the Subwoofer with the correct
polarity.
Note:
• Adjust the speaker volume for the Subwoofer with the controls on the Subwoofers,
not on the DSP-AX1.
■ Impedance Selector switch
Select the position whose requirements your speaker system meets.
(Upper position)
Front Effect:
The impedance of each speaker must be 6
Ω
or higher.
Rear: The impedance of each speaker must be 4
Ω
or higher.
Rear Center:
The impedance of the speaker must be 4
Ω
or higher.
Center: The impedance of the speaker must be 4
Ω
or higher.
Main: If you use one pair of main speakers, the impedance of each
speaker must be 4
Ω
or higher.
If you use two pairs of main speakers, the impedance of each
speaker must be 8
Ω
or higher.
(Lower position)
Front Effect:
The impedance of each speaker must be 8
Ω
or higher.
Rear: The impedance of each speaker must be 8
Ω
or higher.
Rear Center:
The impedance of the speaker must be 8
Ω
or higher.
Center: The impedance of the speaker must be 8
Ω
or higher.
Main: If you use one pair of main speakers, the impedance of each
speaker must be 8
Ω
or higher.
If you use two pairs of main speakers, the impedance of each
speaker must be 16
Ω
or higher.
SPEAKERS
FRONT
REAR
CENTER REAR CENTER
+
–
+
–
+
–
+
–
+
–
+
–
IMPEDANCE SELECTOR
SET BEFORE POWER ON
FRONT
REAR
REAR CENTER
CENTER
MAIN A OR B
A + B
FRONT
REAR
REAR CENTER
CENTER
MAIN A OR B
A + B
WARNING
Do not change the IMPEDANCE
SELECTOR switch setting while the power
to this unit is on, otherwise this unit may be
damaged.
IF THIS UNIT FAILS TO TURN ON
WHEN THE STANDBY/ON SWITCH IS
PRESSED:
The IMPEDANCE SELECTOR switch
may not be set to either end. If so, set the
switch to either end when this unit is in the
standby mode.
(General Model)
Right Rear
Speaker
Left Rear
Speaker
Subwoofer
system