Vitek VT-1511 - Manual (Page 6)

6
ENGLISH
WARMING UP BEVERAGES
You can warm up beverages, by putting the
cappuccinator pipe (7) without a plastic tip
into a cup.
• Press the steam supply button (14), wait
till the indicator (15) lights up.
• Immerse the cappuccinator pipe (7) with-
out a plastic tip into a cup with beverage,
which you want to warm up, carefully turn
the steam supply control handle (5) anti-
clockwise.
• Close steam supply by turning the handle
(5) clockwise till the clamp.
• Switch off steam supply, by pressing the
steam supply button (14) once again.
• Switch off the coffee maker, by press-
ing the (17) ON/OFF button, the indicator
(16) will go out.
Note: small amount of water or steam
can be released from the filter holder
(12) or steam nozzle – it is normal.
HOW TO GET GOOD ESPRESSO
- Use the coffee powder intended specially
for the espresso coffee machines.
- Slightly ram the ground coffee in the filter
(6), you can do it using the back side of
the measuring spoon (18).
- The strength of coffee depends on qual-
ity and the grade of coffee beans grind-
ing. If coffee is pouring out too long this
means the coffee powder is too fine or it
is rammed too strongly.
REMOVING THE SCALE
For effective operation of the coffee mak-
er we recommend to remove scale each
2-3 months, in case of using “hard” water
– more often.
1. Make sure that all functional buttons
(13, 14, 17) are in the off position.
2. To make sure that the steam supply is
blocked, turn the handle (5) clockwise
till the clamp.
3. Make citric acid solution: 2 teaspoons
and 1 l of water and pour this solution
into the water tank (3). Set the tank (3)
on its place.
4. Insert the filter (6) into the holder (12), by
matching the ledge on the filter (6) with
the grove on the holder (12) and turn the
filter (6) clockwise/anticlockwise.
5. Place the filter holder into the coffee
maker. Holder ledges (12) should match
the groves on the boiler, and then turn
the filter holder handle (8) to the right till
the clamp.
6. Put a corresponding cup on the lid of
the tray (10).
7. Inset the plug into the socket.
8. Switch on the unit by pressing the ON/
OFF (17) button, the indicator (16) will
light up.
9. Press the (13) button and fill a cup of 100
ml with water (it is necessary to remove
water from the boiler and fill the boiler
with citric acid solution), switch off wa-
ter supply, by pressing the (13) button
once again.
10. Wait till the indicator (15) lights up, and
switch on water supply, by pressing the
(13) button and fill a cup of 100 ml with
water, press the (13) button once again
to switch off water supply, pour out wa-
ter from the cup.
11. In some time repeat the procedure, de-
scribed in paragraph 10, and fill a cup of
100 ml with water once again.
12. Press the steam supply button (14),
wait till the indicator (15) lights up. Put
a corresponding cup under the cappuc-
cinator pipe (7) and open steam supply,
by turning the handle of the control (5)
anticlockwise. Carefully turn the control
handle (5) to the maximal steam sup-
ply position, release steam for about
1 minute, close steam, by turning the
handle (5) clockwise till the clamp,
switch off steam supply, by pressing the
(14) button.
13. Switch off the coffee maker, by press-
ing the (17) button. Wait for 10 - 15 min-
utes.
1511.indd 6 1511.indd 6 03.02.2010 15:36:16 03.02.2010 15:36:16