Xerox -05W - Manual (Page 159)

9-7
ICL FTF File Transfer
Remote Host Options
This dialog box is displayed by clicking the At Remote Host... button in the FTF
dialog box.
Remote File Operation
Factory default: Make or replace
This specifies what operation should be performed on the file. Click on the arrow
button to display a list of operations supported, then double-click to select the mode
you want to use. The modes which are available are as follows:
Make The file must not exist on the remote system and will be
created. If the file is being sent to VME, this will cause a new
generation to be created if the file already exists.
Replace The file must already exist on the remote system and it will be
replaced by the file to be transferred.
Make or replace The file will be created on the remote system if it does not
already exist, but will replace an existing file of the same
name. This is the mode of access used if you select the direc-
tion of transfer To Host in the main FTF dialog box.
Append The file must exist on the remote system and the data
transferred will be appended to it.
Make or append The file will be created on the remote system if it does not
already exist, but if it does, the transferred data will be ap-
pended to it.