Zenoah EDG2300R - Manual (Page 28)

28
7. Operation
English
■ STOPPING ENGINE
• Gradually decrease the engine speed to an idle
speed, and then slide ignition switch to "STOP"
position.
(1) Ignition switch
(A) RUN
(B) STOP
■ BORING OPERATION (OP6, OP7)
• Keep the engine running at full throttle during
operation.
• Keep the drill going straight. Tilted boring can cause
the drill to bend.
• Avoid touching the spark plug lead during operation.
• Always hold unit firmly with both hands on handles
and body well balanced.
• Operate at a high engine speed and let drill bit do
the work. Do not force bit into hole.
• If material become twisted around drill bit, stop
engine, allow unit to cool and remove wire from
spark plug before attempting to clear bit.
• Stop engine and inspect unit if abnormal vibration or
noise is generated.
How to operate Reverse control (OP8)
• Decrease engine speed to idle and move shift lever
to R (Reverse) position, then accelerate to pull out.
• Shift lever may not move unless engine is running. If
so, turn drill chuck a little bit by hand.
• The purpose of Lock control and Reverse control is
mainly for easy pullout of bit.
(1) Shift lever
OP5
OP6
OP7
OP8