Zenoah EDG2300R - Manual (Page 32)

32
every every every
25 50 100
system/compornent procedure before hours hours hours note
use after after after
fuel leaks, fuel spillage wipe out
✔
fuel tank, air filter, fuel filter inspect/clean
✔ ✔
replace, if necessary
see ■ADJUSTING replace carburetor
idle adjusting screw
✔
IDLING SPEED (p.30) if necessary
clean and readjust GAP: .025in(0.6~0.7mm)
spark plug ✔
plug gap replace, if necessary
cylinder fins, intake air cooling vent clean
✔
muffler, spark arrester, cylinder exhaust port clean
✔
throttle lever, ignition switch check operation
✔
gear case grease ✔
screws/nuts/bolts tighten/replace
✔ ✔
not adjusting screws
■ MAINTENANCE CHART
Maintenance, replacement, or repair of the emission control
device and systems may be performed by any non-road engine
repair establishment or individual.
8. Maintenance
English