Yamaha 01X User Manual

Page 70

Advertising
background image

70

Recording/Playback/Remote Control

01X Owner’s Manual

Before Using

Basics Section

Appendix

Getting Started

Reference

e From the Devices menu, select “VST Outputs.”

r Activate all the outputs buses you intend to use.

Click on the [power] button to activate a desired bus.

(Bus 1 is on by default and doesn’t have such a button.)

Up to nine buses can be activated. In these instruc-

tions, we’ll use the simplest routing system—only

using Bus 1—so leave all the other buses off. (For

instructions on how to use multiple buses and multiple

mLAN channels, see the box below.)

t From the Devices menu, select “Mixer.”

y Make sure all audio tracks are set to Bus 1. (This does

not apply to MIDI tracks.)

First, make sure the tracks are set to full width. Click

on the leftmost down arrow and select “Wide” from the

pop-up menu.

If any track is not set to Bus 1, click the [Bus] box at

the bottom of the channel strip, and select Bus 1 from

the pop-up menu.

u Click the Show Master button (shown below) to display

the stereo master output channel strip.

i To route signals to 01X monitor input, set “MONITOR

17-18” in mLAN Auto Connector (PC

➝ 01X) to

“2CH,” then set the master outputs from the DAW to

Channels 17 and 18, as shown below.

In this setup, all tracks are set to Bus 1 (the default) and

Bus 1 is routed to the mLAN master outputs.

• It is possible to monitor without decreasing the number of input

channels (faders) by using the monitor input function of 01X

(direct monitor).

• When you are using WDM and ASIO simultaneously, refer to

“Setting in the mLAN Auto Connector” in the separate Installation

Guide.

o On the 01X, press the [MONITOR A/B] button so that

the lamp lights.

This enables monitoring of the master outputs from the

DAW/computer.

Keep in mind that this monitor setting can be changed

(page 96). The instructions here apply when the

default setting is used.

Click here

Advertising