ZyXEL Communications ZyXEL ExpWave 240B - Manual (Page 51)

ExpWave 240B Secure Outdoor Ethernet Radio Link
Network Setup 7-1
Chapter 7 Network Setup
This chapter describes how to configure the Network Setup using Menu 6 — Network Setup.
7.1 Introduction
From the main menu, enter 6 to open Menu 6 – Network Setup.
Figure 7-1 Menu 6 - Router Mode Network Setup and Status
Table 7-1 Network Setup Field
FIELD DESCRIPTION
Operation Mode Set AC Enable or Disable.
Device ID AP set to 1 , AC1 set to 2 , AC2 set to 3.
Pre_Share Key Set the key for AP to AC make authentication.
Ethernet (LAN) Setting
LAN IP Enter the IP address of device lan port in dotted decimal notation.
Network Mask Device will automatically calculate the subnet mask based on the IP
address that you assign. Unless you are implementing subnetting, use the
subnet mask computed by the Devie.
RIP Directio Press the [SPACE BAR] to select the RIP direction from Both/In
Only/Out Only/None.
RIP Version Press the [SPACE BAR] to select the RIP version from
RIP-1/RIP-2B/RIP-2M.
DHCP Edit Type space bar change Yes or No , if select Yes and enter SMT6.1.
Wireless (WLAN) Setting
MAC Address Indicate the station with the same mac address will only be accepted to
join in.
VPN Security Set security level (None, Low , Medium , High) for AP and AC conection
AC1 & AC2 VPN
Security Set security level (None, Low , Medium , High) for AC1 and AC2
connection
The VPN security level parameters of authentication & encryption are described in Table 7-2:
Menu 6 - Router Mode Network Setup
AP AC1 AC2
Operation mode: Enabled Disabled
Device ID: 1 2 N/A
Pre_Share Key: 951753258 N/A
Ethernet (LAN) Setting:
LAN IP: 192.168.80.217 192.168.223.1 N/A
Network Mask: 255.255.255.0 255.255.255.0 N/A
RIP Direction: Both Both N/A
RIP Version: RIP-2B RIP-2B N/A
DHCP Edit: No N/A
Wireless (WLAN) Setting:
MAC Address: 00:02:CF:13:46:79 N/A
VPN Security: None N/A
AC1&AC2 VPN Security: High
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.