ZyXEL Communications ZyXEL ExpWave 240B - Manual (Page 86)

ExpWave 240B Secure Outdoor Ethernet Radio Link
13-2 Firmware & Configuration File Maintenance
Figure 13-3 Menu 24 — System Maintenance
Enter 10 to go to Menu 24.10 - System Maintenance - Time and Date Setting to update the time and date settings
of your ExpWave as shown in the following screen.
Figure 13-4 Menu 24.10 System Maintenance — Time and Date Setting
Table 13-1 Time and Date Setting Fields
FIELD DESCRIPTION
Enter the time service protocol that your time server sends when you turn on the
ExpWave. Not all time servers support all protocols, so you may have to check with
your ISP/network administrator or use trial and error to find a protocol that works.
The main differences between them are the format.
Daytime (RFC 867) format is day/month/year/time zone of the server.
Time (RFC-868) format displays a 4-byte integer giving the total number of
seconds since 1970/1/1 at 0:0:0.
NTP (RFC-1305) the default, is similar to Time (RFC-868).
Use Time Server
when Bootup
None enter the time manually.
Time Server
Address Enter the IP address or domain name of your time server. Check with your
ISP/network administrator if you are unsure of this information. The default is
tick.stdtime.gov.tw
Current Time This field displays an updated time only when you reenter this menu.
New Time Enter the new time in hour, minute and second format.
Current Date This field displays an updated date only when you reenter this menu.
New Date Enter the new date in year, month and day format.
Time Zone Press [SPACE BAR] and then [ENTER] to set the time difference between your
time zone and Greenwich Mean Time (GMT).
Daylight Saving If you use daylight savings time, then choose Yes.
Menu 24.10 - System Maintenance - Time and Date Setting
Use Time Server when Bootup= NTP (RFC-1305)
Time Server Address= tick.stdtime.gov.tw
Current Time:
00 : 00 : 00
New Time (hh:mm:ss): 11 : 23 : 16
Current Date: 2000 - 01 - 01
New Date (yyyy-mm-dd): 2001 - 03 - 01
Time Zone= GMT+0800
Daylight Saving= No
Start Date (mm-dd): 01 – 01
End Date (mm_dd): 01 – 01
Press ENTER to Confirm or ESC to Cancel:
Menu 24 - System Maintenance
1. System Status
2. System Information and Console Port Speed
3. Log and Trace
4. Diagnostic
5. Backup Configuration
6. Restore Configuration
7. Firmware Update
8. Command Interpreter Mode
10. Time and Date Setting
11. Remote Management Setup