2 system information and console port speed, 1 system information – ZyXEL Communications ZyXEL ExpWave 240B User Manual

Page 68

Advertising
background image

ExpWave 240B Secure Outdoor Ethernet Radio Link

11-2

System Maintenance

The following table describes the fields present in Menu 24.1 - System Maintenance - Status. These fields are
READ-ONLY and are meant to be used for diagnostic purposes. The upper right corner of the screen shows the time
and date according to the format you set in menu 24.10.

Table 11-1 System Maintenance — Status Menu Fields

FIELD

DESCRIPTION

Port

Identifies a port (Wireless or LAN ) on the ExpWave.

Status

Shows the port speed and duplex setting if you’re using Ethernet Encapsulation
and Down (line is down), 100M or 10M and Full or Half.

TxPkts

The number of transmitted packets on this port.

RxPkts

The number of received packets on this port.

Cols

The number of collisions on this port.

Tx B/s

Shows the transmission speed in Bytes per second on this port.

Rx B/s

Shows the reception speed in Bytes per second on this port.

Up Time

Total amount of time the line has been up.

Ethernet Address

The Ethernet address of the port listed on the left.

IP Address

The IP address of the port listed on the left.

IP Mask

The IP mask of the port listed on the left.

DHCP

The DHCP setting of the port listed on the left.

System up Time

The total time the ExpWave has been on.

CPU Load

Specifies the percentage of CPU utilization.

You may enter 9 to reset the counters or [ESC] to return to menu 24.

11.2 System Information and Console Port Speed

This section describes your system and allows you to choose different console port speeds. To get to the System
Information and Console Port Speed:
Step 1.

Enter 24 to go to Menu 24 – System Maintenance.

Step 2.

Enter 2 to open Menu 24.2 - System Information and Console Port Speed.

Step 3.

From this menu you have two choices as shown in the next figure:

Figure 11-3 Menu 24.2 — System Information and Console Port Speed

11.2.1 System Information

System Information gives you information about your system as shown below. More specifically, it gives you
information on your routing protocol, Ethernet address, IP address, etc.

Menu 24.2 - System Information and Console Port Speed

1. System Information

2. Console Port Speed

Please enter selection:

Advertising