Xerox 701P91273 - Manual (Page 46)

XPrint UNIX SYSTEM PRINTER DRIVER INSTALLATION 15-2
Appendix B Setting the IP address with the Control Panel
1. Press On Line button on the Control Panel. Be sure the light next to it is OFF
2. Press Menu . The ON-LINE message disappears and TOP MENU is
displayed.
3. Press
Up+
until
<COMMUNICATIONS>
appears on the Display Panel and then
press Enter.
4. Press
Up+
until
<NETWORK SETUP>
is displayed and then press Enter.
5. Press
Up+
until
<TCP/IP>
is displayed and then press Enter.
6. Press Enter while
<IP ADDRESS>
is displayed.
7. Press Enter while
<DYNAMIC>
is displayed.
8. Press
Up+
until
<NO>
is displayed and then press Enter.
9. Press Enter while <SET IP ADDRESS> is displayed.
10. Press Up+ to increase the digit value. Press Down- to decrease the digit value.
When each digit is correct, press Next button to move on to the next digit.
11. The Next button wraps around the display without setting the value if an error is
made. After the complete IP address is displayed correctly, press Enter. The IP
address is now set
12. Reset Printer to have new settings take effect.