Xerox 701P91273 - Manual (Page 48)

XPrint UNIX SYSTEM PRINTER DRIVER INSTALLATION 15-4
Appendix D Setting a SUBNET MASK at the Control Panel
1. Press On Line button on the Control Panel. Be sure the light next to it is OFF
2. Press Menu . The ON-LINE message disappears and TOP MENU is
displayed.
3. Press
Up+
until
<COMMUNICATIONS>
appears on the Display Panel and then
press Enter.
4. Press
Up+
until
<NETWORK SETUP>
is displayed and then press Enter.
5. Press
Up+
until
<TCP/IP>
is displayed and then press Enter.
6. Press
Up+
until
<NET MASK>
is displayed and then press Enter.
7. To set each digit of the subnet mask, press
Up+
to increase the digit value.
Press Down- to decrease the digit value. When each digit is correct, press Next
button to move on to the next digit.
8. The Next button wraps around the display without setting the value if an error is
made. After the complete IP address is displayed correctly, press Enter. The IP
address is now set.
9. Reset Printer to have the new settings take effect.