Zanussi ZKH 2105 - Manual (Page 17)

17
the «O» position and after you have selected
the programme again.
• The door will be locked throughout the delay
time. If you need to open the door, you must
first set the washer dryer to PAUSE by
pressing button 8 . After you have closed the
door, press the same button again.
Note!
The Delay Start cannot be selected with
«Drain» programme.
Display
The display shows the following information:
After selecting a programme the duration of
the selected programme appears in minutes
or hours and minutes on the display .(e.g.
2.05 )
During the program-
me, the time remai-
ning is updated every
minute.
Selected drying time
After selecting a drying programme programme
the drying time is shown in minutes or hours
and minutes.
After the programme
has started, the time
remaining is updated
every minute.
The Delayed start appears on the display for
about 3 seconds, then the duration of the
previously selected programme is displayed.
1.00
2.00
The delay time value
decreases by one
unit every hour, 90
minutes and then,
when 1 hour remain,
every minute.
The incorrect option selection is indicated
by the message Err displayed for a few
seconds and by flashing of the red light button
8 .
In the event of operating problems, some
alarm codes can be displayed, (see para-
graph “Something not working”).
The End of programme or the stop wit
water left in the tub is indicated by a flashing
zero « 0 ».
Start the programme by pressing button 8
To start the selected programme, press this
button; the corresponding green pilot light
stops flashing.
The pilot light
9 illuminates to indicate that the
appliance starts operating and the door is
locked.
0
E20
132960310.qxd 23/10/2008 12:09 Pagina 17