Zanussi ZKH 2105 - Manual (Page 33)

33
Directly into a drain pipe at a height of not
less than 60 cm and not more than 90 cm. The
end of the drain hose must always be
ventilated, i.e. the inside diameter of the drain
pipe must be larger than the outside diameter
of the drain hose.
The drain hose must not be kinked.
IMPORTANT!
Before connecting the machine to new
pipework or to pipework that has not been
used for some time, run off a reasonable
amount of water to flush out any debris that
may have collected in the pipes.
Electrical connection
This machine is designed to operate on a 220-
230 V, single-phase, 50 Hz supply.
Check that your domestic electrical installation
can take the maximum load required (2.2 kW),
also taking into account any other appliances
in use.
Caution!
Connect the machine to an earthed socket.
The manufacturer declines any
responsibility for damage or injury through
failure to comply with the above safety
precaution.
Caution!
Should the appliance power supply cable
need to be replaced, this MUST be carried
out by our Service Centre.
NOTE
Please ensure that when the appliance is
installed it is easily accessible for the
engineer in the event of a breakdown.
Permanent connection
In the case of permanent connection it is
necessary that you install a double pole
switch between the appliance and the
electricity supply (mains), with a minimum gap
of 3mm between the switch contacts and of a
type suitable for the required load in
compliance with the current electrical
regulations.
The switch must not break the yellow and
green earth cable at any point.
132960310.qxd 23/10/2008 12:09 Pagina 33