Zanussi ZKH 2105 - Manual (Page 25)

25
Malfunction Possible Cause / Solution
The washer-dryer does not start:
The door has not been closed. E40
• Close firmly the door.
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The selector dial is not correctly positioned and the
button 8 has not been pressed.
• Please turn the selector dial and press the button 8
again.
The Child Safety Lock or the Delay start function
option has been selected.
• Disable the «Child Safety Lock» or the «Delay
start» function.
The machine does not fill:
The water tap is closed. E10
• Open the water tap.
The inlet hose is squashed or kinked.
E10
• Check the inlet hose connection.
The filter in the inlet hose is blocked.
E10
• Clean the water inlet hose filter.
The door is not properly closed.
E40
• Close firmly the door.
Something not working
IMPORTANT!
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily
without calling out an engineer. Before contacting your local Service Centre, please carry out the
checks listed below.
During machine operation it is possible that the red pilot light of the button 8 flashes, the buzzer
sounds and one of the following alarm codes appears on the display to indicate that the machine
is not working.
●
E10 : problem with the water supply
●
E20 : problem with water draining
●
E40 : door open.
Once the problem has been eliminated, press the button 8 to restart the programme. If after all
checks, the problem persists, contact your local Service Centre.
132960310.qxd 23/10/2008 12:09 Pagina 25