5 tunnel protocol attribute, 3 supported radius attributes, Table 49 supported tunnel protocol attribute – ZyXEL Communications ZyXEL Dimension GS-2024 User Manual

Page 148

Advertising
background image

Chapter 19 Authentication & Accounting

GS-2024 User’s Guide

148

19.2.5 Tunnel Protocol Attribute

You can configure tunnel protocol attributes on the RADIUS server (refer to your RADIUS
server documentation) to assign a port on the Switch to a VLAN based on IEEE 802.1x
authentication. The port VLAN settings are fixed and untagged. This will also set the port’s
VID. The following table describes the values you need to configure. Note that the bolded
values in the table are fixed values as defined in RFC 3580.

19.3 Supported RADIUS Attributes

Remote Authentication Dial-In User Service (RADIUS) attributes are data used to define
specific authentication, and accounting elements in a user profile, which is stored on the
RADIUS server. This section lists the RADIUS attributes supported by the Switch.
Refer to RFC 2865 for more information about RADIUS attributes used for authentication.
Refer to RFC 2866 and RFC 2869 for RADIUS attributes used for accounting.
This section lists the attributes used by authentication and accounting functions on the Switch.
In cases where the attribute has a specific format associated with it, the format is specified.

Egress Bandwidth

Assignment

Vendor-Id = 890
Vendor-Type = 2
Vendor-data =

egress rate (Kbps in decimal format)

Privilege Assignment

Vendor-ID = 890
Vendor-Type = 3
Vendor-Data = "shell:priv-lvl=N"
or
Vendor-ID = 9

(CISCO)

Vendor-Type = 1

(CISCO-AVPAIR)

Vendor-Data = "shell:priv-lvl=N"
where

N

is a privilege level (from 0 to 14).

Note: If you set the privilege level of a login account differently

on the RADIUS server(s) and the Switch, the user is
assigned a privilege level from the database (RADIUS or
local) the Switch uses first for user authentication.

Table 48 Supported VSAs

FUNCTION

ATTRIBUTE

Table 49 Supported Tunnel Protocol Attribute

FUNCTION

ATTRIBUTE

VLAN Assignment

Tunnel-Type = VLAN(13)
Tunnel-Medium-Type = 802(6)
Tunnel-Private-Group-ID =

VLAN ID

Note: You must also create a VLAN with the specified VID on

the Switch.

Advertising