Zenoah G240RC - Manual (Page 17)

17
SERVICE GUIDE
3) ASSEMBLING ROTOR
Insert the gauge(3330-97310) in between the rotor
magnet metal and the coil.Tighten screws while pressing
the coil against the rotor.
Air Gap 0.3 ~ 0.4mm
4) REMOVING PISTON PIN
1. Remove snap rings from both sides of the piston pin.
2. Engage the rod assy(1101-96220) to the piston pin
and gently tap with a plastic hammer to push out the
pin while holding piston firmly.
Hard hammering may damage the big end of the
connecting rod.
NOTE
Wrench
Air Gap Gauge
Ignition Coil
Plastic
Hammer
Rod Assy
Piston