Zanussi ZWF 1650W - Manual (Page 11)

11
CONTRAST
The Contrast setting allows you to modify the optical
characteristic of the display.
Example:
1. Enter the “Menu” option and select the Contrast
setting.
2. Use the CHANGE button to set up the desired
contrast level.
BRIGHTNESS
The Brightness setting allows you to modify the
backlight intensity of the display.
Example:
1. Enter the “Menu” option and select the Brightness
setting.
2. Use the CHANGE button to set up the desired
brightness level.
Note:
At the end of the programme if no button is pressed for
approximately 10 minutes the backlight intensity goes
off.
Change Options Exit
Brightness
B
Temp. Spin Change Options Exit
Brightness
A
Temp. Spin
Change Options Exit
Contrast
B
Temp. Spin Change Options Exit
Contrast
A
Temp. Spin
7 START/PAUSE button
This button has 2 functions:
• Start: after you have selected the desired programme
and options, press this button to start the washing
machine. The light close to the button will stop
flashing and remain lit.
If you have selected a delay time option, the countdown
will begin and will be shown on the display.
• Pause: when you press this button again, the
programme in progress is interrupted. The light close
to the button will start flashing. To restart the
programme, press the button again.
When you PAUSE the cycle, it becomes possible to
open the door if:
• The washing machine is not in the heating phase;
• The level of the water is not high;
• The drum is not turning.
Important! You must set the washing machine to
PAUSE before you make any change in the programme
in progress.
Start/
Pause
132989090.qxd 24/05/2004 15:46 Pagina 11 (Nero/Process Black pellicola)