Yamaha RX-V2400 - Manual (Page 77)

73
English
ZONE 2/ZONE 3 (U.S.A., CANADA AND AUSTRALIA MODELS ONLY)
A
D
V
ANCED
OPERA
T
ION
Using this unit’s internal amplifier
To use this unit’s internal amplifier, select ON in ZONE2 AMP.
The supplied remote control can be used to control Zone
2/Zone 3. You can even select the input source and control
components located in the main room directly from the
second/third room regardless of the listening condition in
the main room.
■ To enable Zone mode on the remote
control
You will be able to switch the remote control mode from
one room to another, and use STANDBY, SYSTEM
POWER, MUTE and VOLUME +/– to control the
selected room.
1
Set REC OUT/ZONE 2 on the front panel to
SOURCE/REMOTE.
2
Repeat steps 1 and 2 of the procedure in
“Setting manufacturer codes” on page 60.
3
Press l / h to select “L:AMP”.
4
Press k / n to select “Zone”.
5
Press LEARN to complete the Zone setup.
The remote control will be able to operate this unit
from Zone 2 or Zone 3.
■ To control Zone 2/Zone 3
1
Press SOURCE SELECT k repeatedly to
display “Zone2” or “Zone3” in the display
window.
2
Press SYSTEM POWER to turn Zone 2 or
Zone 3 power on.
3
Press an input selector button to select the
input source you want to listen to in the
second/third room.
The display window shows “2: name of selected
input” if the remote control is in the Zone 2 mode.
Signals input to V-AUX and PHONO jacks cannot be sent to
Zone 2/Zone 3.
R L
+
–
PRESENCE/ ZONE 2
Second room
This unit
Remote controlling Zone 2/Zone 3
SOURCE
/REMOTE
REC OUT/ZONE 2
MD/TAPE DVD
DTV
CBL/SAT
VCR 1
CD-R
TUNER
CD
DVR
/VCR2
ENTER
ENTER
Note
LEARN
SELECT
SOURCE
or
CD
DVD DVR/VCR2 VCR 1 DTV CBL/SAT
CD-R MD/TAPE TUNER
00_RX-V2400U_EN.book Page 73 Friday, October 10, 2003 10:54 AM