Zanussi ZWN 6120 L - Manual (Page 22)

If the outlet spigot has not
been used before, remove
any blanking plug that
may be in place.
Push the drain hose onto
the spigot and secure with
a clip, ensure a loop is
formed in the drain hose
(see above) to prevent
waste from the sink enter-
ing the appliance.
If you intend to drain the hose from the machine into a
sink, make sure that the sink is empty and the plug hole
is not blocked. Use the plastic “U - Piece” supplied.
In the interest of the environment
The appliance should be connected to the FOUL drainage
system, the water will then be taken to a sewage works for
treatment before being discharged safely into a river.
It is essential that these appliances are not connected to
the surface water drainage system as this water is dis-
charged directly into a river or stream and may cause pol-
lution.
If you require any further advice please contact your local
water authority.
SHOWER
WASHING
MACHINE DISHWASHER
BATH
SINK TOILET
BIDET
RAINWATER
‘RUN-OFF’
SURFACE WATER
DRAINS & SEWERS
UNTREATED
DISCHARGE
RIVER RIVER
TREATED DISCHARGE
FOUL DRAIN
FOUL SEWERS
SEWAGE TREATMENT
WORKS
Electrical connection
Any electrical work required to install this appliance
should be carried out by a qualified electrician or compe-
tent person.
Warning! THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability should this
safety measure not be observed.
Before switching on, make sure the electricity supply
voltage is the same as that indicated on the appliance’s
rating plate.
Warning! Information on the electrical connection is
given on the rating plate on the inner edge of the
appliance door.
The appliance is supplied with a 13 amp plug fitted.
In the event of having to change the fuse in the plug sup-
plied, a 13 amp ASTA approved (BS1363/A) fuse must be
used.
Warning! A cut off plug inserted into a 13 amp
socket is a serious safety (shock) hazard.
Ensure that the cut off plug is disposed of safely. Should
the appliance power supply cable need to be replaced, this
MUST be carried out by our Service Force Centre. The
appliance should not be connected to the electrical supply
by means of an extension cable.
Note!
When the appliance is installed the power supply cable
must be accessible.
Environment concerns
The symbol on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it should be taken to the
appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential
negative consequences for the environment and human
health, which could otherwise be caused by inappropriate
waste handling of this product. For more detailed
information about recycling of this product, please contact
22