Xerox 7232 User Manual
Page 112
8 Microsoft Networking
102
Xerox WorkCentre 7232/7242 System Administration Guide
7.
Select [SMB], and then [Change Settings].
8.
Select [Port Status] and [Change Settings].
9.
Select [Enabled], and then [Save].
Next, establish TCP/IP if you use an IP address for your network environment.
1.
In [Connectivity & Network Setup], select [Protocol Settings].
2.
Select [Protocol Settings].
3.
Under [TCP/IP - IP Mode], select [IPv4 Mode], [IPv6 Mode], or [Dual Stack].
When [IPv4 Mode] or [Dual Stack] is selected
4.
Select [IP Address Resolution], and then [Change Settings].
5.
Select a method for establishing an IP address from [DHCP], [BOOTP], [RARP],
[DHCP/Autonet], and [STATIC], and then select [Save].
NOTE: Use the DHCP server together with the Windows Internet Name Server
(WINS) server.
If you selected [STATIC] in step 5, then proceed to step 6 to configure the protocol
settings. Otherwise, proceed to step 12.
6.
Select [IPv4 - IP Address], and then [Change Settings].
7.
Use the keypad on the screen to enter the IP Address for the machine in the
format “xxx.xxx.xxx.xxx”. When you have finished entering all values, select
[Save].
8.
Select [IPv4 – Subnet Mask], and then [Change Settings].
9.
Using the same method as in step 7, enter the Subnet Mask.
10.
Select [IPv4 – Gateway Address], and then [Change Settings].
NOTE: If you do not wish to set the gateway address, leave this field blank.
11.
Using the same method as in step 7, enter the Gateway Address.
12.
To enable IPv4 – IP Filtering, use CentreWare Internet Services to register the IP
addresses that will not be allowed to access the machine.
NOTE: If you do not wish to use the IP filter feature, select [Disabled].
NOTE: If you enable IP Filtering at the machine user interface without first configuring
it through Internet Services, then you will not be able to access the machine’s Internet
Services web page or print to the machine.
13.
When you have finished establishing TCP/IP, select [Close] on the [Protocol
Settings] screen.
When [IPv6 Mode] or [Dual Stack] is selected
4.
Set [IPv6 Address Manual Configuration].