Zanussi ZWD 12270 S1 - Manual (Page 21)

6. Start the programme by pressing the button
. After the programme has started, the
time remaining on the display is updated
every minute.
7. At the end of the programme the buzzer
sounds. Three flashing zeros « 0.00 »
appear on the display .
At this point of the programme, starts an
anti-crease phase which lasts about 10
minutes. During this time the door is locked
and the display keeps showing the flashing
zeros «
0.00 ».
(If you wish to open the door before or dur-
ing the anti-crease phase, please follow the
instructions given in the previous chapter).
7. Turn the selector dial to the «Off» position
to switch the machine off.
8. Remove the laundry.
6
21
The recommended load to wash and dry in
your washer-dryer is 3 kg for cotton and 2 kg
for synthetics.
Note!
It is possible also to wash and dry up to 4
kg of cotton items (see the drying times
table).
Do not use a dosing device/ball when carrying
out a washing & drying programme.
1. Load the laundry.
2. Add detergent and fabric softener.
3. Switch the machine on by turning the
selector dial to the selected wash pro-
gramme/fabric.
4. Select the drying time by pressing button
(see the drying programmes).
5. Select the required options by pressing the
relevant buttons. The display shows the
entire duration of the washing and the
selected drying cycle.
If possible, do not select a spin speed
lower than that proposed by the appliance
to avoid a too long drying time so saving
energy.
In any case the reduction of the spin speed
is only possible after selecting drying. The
lowest values you can select are the follow-
ing:
- 900 r.p.m. for cottons
- 700 r.p.m. for synthetics
7
NON-STOP programme (Washing and Timed Drying)