Zanussi ZWD 12270 S1 User Manual
Page 33
33
When discharging into a standpipe ensure that
the top of the standpipe is no more than 90 cm
(35.4'') and no less than 60 cm (23.6'') above
floor level.
The drain hose may be extended to a
maximum of 4 metres. An additional drain hose
and joining piece is available from your local
Service Force Centre. The joining piece must
have an internal diameter of 18mm.
If your drain hose
looks like this (see
below) you do not
require the «U» piece.
Just push the hose
firmly into the
standpipe.
2. Onto a sink outlet spigot.
If the outlet spigot has not been used before,
remove any blanking plug that may be in place.
Push the drain hose onto the spigot and secure
with a clip, ensure a loop is formed in the drain
hose (see diagram) to prevent waste from the
sink entering the washer-dryer.
Loop
1000
6kg
40°
30°
Rinse
Delicates
ZWF10070W
Off
Special
95°
Sport 40°
60° Eco
Sport Shoes 40°
60°
40° Eco
Silk
40°
50°
40°
Mini 30'
Hand
Wash
Cold
30°
Drain
Spin
Wool
Cottons
Synthetics
Easy Iron 40°
Start/Pause
Wash
Door
End
Extra Rinse
Options
Spin
1000
900
700
Prewash
Intensive
Super
Quick
3h
6h
9h
Min.
60 cm (23.6)
Max.
90 cm (35.4)
Important!
Before connecting the machine to new
pipework or to pipework that has not been
used for some time, run off a reasonable
amount of water to flush out any debris that
may have collected in the pipes.
In the interest of the environment
Washer-dryers should be connected to the
FOUL drainage system, the water will then be
taken to a sewage works for treatment before
being discharged safely into a river. It is
essential that these appliances are not
connected to the surface water drainage
system as this water is discharged directly into
a river or stream and may cause pollution.
If you require any further advice please contact
your local water authority.
SHOWER
BATH
SINK
TOILET
BIDET
WASHING
MACHINE
DISHWASHER
RAINWATER
'RUN-OFF'
SURFACE WATER
DRAINS & SEWERS
UNTREATED
DISCHARGE
RIVER
FOUL DRAIN
FOUL SEWERS
SEWAGE
TREATMENT
WORKS
RIVER
TREATED
DISCHARGE